Zinsser BIN Aqua

NEW PRODUCT AVAILABLE SOON

B-I-N® AQUA- is a ground-breaking water-based formula, developed for both professional and commercial applications.

• Ultra-low odour.

• Contains only trace VOCs (<0.1%).

• Interior and exterior use.

• Effectively primes, seals and blocks stains.

• Locks in problem odours.

• Superior adhesion without the need for sanding.

• Blocks knot stain and sap streaks

Priming- Use as a full-surface primer on wood panels, building boards, doors, frames, PVC, plywood, concrete, glossy paint and varnish, non-ferrous metal such as galvanised metal, copper, aluminium and stainless steel and other paintable surfaces. Spot-Priming

B-I-N® AQUA is excellent for spot priming- knots, resin, stains, etc, and is also ideal for interior spot priming of water stains. Note that the primer on spotprimed areas with a porous surface may show through if the topcoat has poor coverage. This also applies to many ceiling paints and shiny enamels – only use a topcoat with good coverage. For best results bring forward spot primed areas by allowing a minimum of 45 minutes for the spot primed area to dry before overcoating with a full coat of B-I-N® AQUA to the whole area, or to a natural break.

Sealing- B-I-N® AQUA penetrates and seals porous surfaces and dries to a smooth finish with excellent hiding properties. B-I-N® AQUA is an excellent primer for enamel and is ideal for wood, new cured plaster, concrete and concrete block, stucco, drywall, joint compound, uncoated wallcovering and other porous surfaces.

Stain & Odour Blocking- B-I-N® AQUA will effectively block stains from water, nicotine, grease, oil, soot, mildew, tannin, crayon and lipstick. B-I-N® AQUA is also an outstanding odour barrier and effectively blocks all types of odours including fire damage, smoke, nicotine, mildew, pet urine and odour from fireplaces and heaters.

Application- Shake or stir well before use. Apply using a brush, roller or sprayer (follow manufacturer’s instructions for sprayers; for airless spraying, use 0.015–0.017” tip at 1700-2200 psi).

Thinning- is not normally required, however, if necessary, add no more than 5% clean water. Do not thin if using for stain, knot or odour blocking.

Dry Time- At normal temperatures, B-I-N® AQUA is touch dry in 25 minutes and can be recoated in 45 minutes. Lower temperatures, higher humidity, and the addition of tint will prolong the dry and cure time of the product. For knots and stains, allow 2 hours to dry. When sealing water stains, some stains may appear in the primer as it dries, this is normal. Stains will be locked into the primer film and will not bleed into the topcoat.

Coverage- Up to 9m2 per litre. Coverage may vary depending upon method of application and surface porosity.